Summary of technical data for ST-Poly APET
| Thickness | 0.5 | mm | |
| Specific gravity | 1.34 | g/ cm sq | |
| Surface resistance | 1 x 10E5 | Ohms per square | |
| Surface resistance after elongation | 100% | 3 x 10E5 | Ohms per square |
| 150% | 1 x 10E6 | ||
| 200% | 1 x 10E7 | ||
| Surface resistance after abrasion | 5 x 10E5 | Ohms per square | |
| Light transmission ratio | 60 (Spectral photometer 550nm) | % | |
| Softening point | 80 | Degrees centigrade | |
| Tensile elasticity | 18,800 | Kg/cm sq | |
| Yield strength | 470 | Kg/cm sq | |
| Break Strength | 560 | Kg/cm sq | |
| Elongation | 680 | % | |
| Impact strength | 970 | N | |
| Absorptive capacity | 0.4 | % | |
Download ST-Poly Technical Data
Available Thicknesses:
0.5mm, 0.65mm, 0.9mm,
1.2mm
Available Widths:
610mm and 640mm.
Applications:
Hard Disk Drive (Spindle motor,
HSA, HDD)
IC Chip
FPC
LCD Module
Medical equipment
Flat panel
display
ST-Poly APET is a static dissipative (10^5
)
thermoformable sheet made by our partner Achilles in
Japan.
ST-Poly provides various Industries affected by ESD problems with a clean, low-cost, re-washable, transparent ESD packaging solution. ST-Poly contains no carbon, no metal, and no corrosive agents. It is very clean and can be used in the toughest cleanrooms AND be rewashed in either ultrasonic DI or IPA without any degradation or contamination.
ST-Poly APET trays are the low cost, clean and transparent recyclable alternatives to expensive, contaminating, non-transparent vacuum formed trays. Never has a truly static dissipative material been transparent to the point of barcode scannability until ST-Poly.
Features:
Washable
Not
affected by humidity
Low degredation over time
Excellent
recyclability
Transparent
Extremely clean
(low outgassing, low
particles, low ionic contamination)
Low Cost